Some Video of my goofing around setting up the lathe.
Jog mode can be set to continuous or at steps on the lathe in EMC2, .0001" is the smallest.
Running a sample part in EMC2, It is a chess piece, but I am cutting air. I am just setting up the lathe and running some sample gcode to make sure things are working. I actually don't have a cutter handy anyway.
This is from a couple days ago, I was testing the stepper motor speed and acceleration in EMC2's stepper motor setup. I don't think I was actually running the speeds and accelerations listed because I did have to change the settings later on.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment